- Rated pressure: the recommended pressure is 160 bars, reaching a maximum value of 210 bars.
- Recommended lubricant: hydraulic mineral oil belonging to H-LP (H-LP32), (H-LP46), (H-LP68).
- Oil filtering: keep it always efficient through the use of appropriate filters and their periodical replacement. It is necessary to assume a filtering ratio of 25 μ.
- Oil temperature used: during operation, keep temperature between 40-50°C, avoid exceeding 80°C. High temperatures diminish oil slimming cause an insufficient lubrication of the moving parts, as well as a reduction in performance and life of the cylinder.
- Outside rod: during operation, never subject the rod to radial weights.
- Welding: unscrew the rod completely before welding possible accessories on the bottom of the cylinder or at the end of the rod. Make sure the welding cools down before putting the rod back in place. To avoid contact between welding drops and the chromed rod consequently ruining it, protect the rod in a suitable way. Absolutely avoid welding on the outside diameter of the cylinder.
- Painting: when painting the cylinder by furnace dessication, do not exceed 80°C. When cold painting the cylinder with the installed outside rod, make sure to protect the rod from paint to avoid damages on the scraping and rod seal.
- Danger: the products and the material used are not dangerous. However, the installation process for the cylinders may be dangerous; therefore, install the appropriate stop valves or addition al security systems according to the machine operational regulations. We do not hold ourselves responsible for any damages due to the non-observance of the above-mentioned warnings and safety measures, as well as of to improper use of the cylinder.
- Warranty: we will replace or repair defective articles for free, within a year from the time of delivery. This warranty does not cover damages caused by the use of: defective articles; worn out articles; wrong use of the articles or obvious tampering of the articles. The return of defective articles must be done, upon our confirmation, ex-works/franco domicile, indicating all relevant data referring to your purchase order in the delivery note.
- Maintenance: replace worn out seals when needed. Particular attention should be paid to the quality and the good state of the lubricant as well as to the prevention from jack fouling.
